You can transfer data between a LOGO! Base Module and the LOGO!Soft Comfort with subordinate menu commands under this menu.
Prerequisites
To transfer data between the LOGO! Base Module and the LOGO!Soft Comfort, you must configure a communication interface with menu command "Tools -> Options: Interface" of the LOGO!Soft Comfort, and prepare the LOGO! Base Module for data transfer with menu setting "PC/Card → PC ↔ LOGO!".
| Note For the data transfer, the LOGO! Base Module must not be in RUN mode or editing mode. For further information about the menu setting "PC/Card → PC ↔ LOGO!", refer to LOGO! Manual. |
Menu commands overview
The Tools → Transfer menu contains the following menu commands:
Tools → Transfer: Configure Network Address
Tools → Transfer: Configure Normal/Slave Mode
Tools → Transfer: Switch LOGO! Mode
Tools → Transfer: Summer time/Winter time
Tools → Transfer: Clear User Program and Password
Tools → Transfer: Set LOGO! TD Power-on Screen
Tools → Transfer: Hours counter
Tools → Transfer: Show FW version